Installation Instructions

W10367612A - 5-

24. Reassemble the front panel in the reverse order. (Refer to

steps 7 and 8).

Before closing top, check the following:

a. Belt should be centered and tight on drum.

b. Wire clips holding the door switch wires must be

anchored in slot in top of front panel and along top

edge of side panel. See Figure 10.

FIGURE 10

c. Make sure door switch leads are connected.

d. Close top, reinstall the two (2) screws in the lint

screen area and reinstall lint screen

25. Plug in dryer or reconnect power.

26. To make sure the dryer is working properly:

a. Turn on dryer.

b. Run on high for 5 minutes.

c. Check for heat in drum.