Instruction Sheet

ManualsBrandsMaytag ManualsDishwasher AccessoriesDishwasher Floor Mounting Kit

INSTRUCTION SHEET

for Dishwasher Floor Mounting Kit

Instruction Sheet 8171478 6/00

wWARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all panels before operating.

Failure to do so can result in death or electrical shock.

Kit Contains:

2 Mounting Brackets

1 Instruction Sheet

NOTE: Floor mounting screws not supplied, must

purchase locally.

Instructions:

1. Remove two (2) screws from the access panel.

See Figure 1.

2. Carefully remove access panel and toe panel.

3. Position dishwasher in its finished installation position.

See dishwasher installation instructions for proper

installation position.

Figure 2

Install brackets in these locations.

Place as far back as possible.

5. Mark location of hole on the floor for your lag screws.

6. Remove dishwasher and drill two (2) holes.

NOTE: Hole drill size will depend on size of lag screw

being used for installation. Lag screws not supplied.

Suggest

⁄4" lag screws, length determined at

installation.

Figure 1

Access

panel

Screws

4. Place floor mounting brackets on the inside of the

side braces as shown in Figure 2. The floor mounting

brackets must be at least 10" (254 mm) from the front

edge of the side brace.

(continued)

Summary of content (4 pages)

PAGE 1
INSTRUCTION SHEET for Dishwasher Floor Mounting Kit wWARNING Electrical Shock Hazard Disconnect power before servicing. Replace all panels before operating. Failure to do so can result in death or electrical shock. Kit Contains: 2 Mounting Brackets 1 Instruction Sheet NOTE: Floor mounting screws not supplied, must purchase locally. 4. Place floor mounting brackets on the inside of the side braces as shown in Figure 2.
PAGE 2
wWARNING Tip Over Hazard Do not use dishwasher until completely installed. Do not push down on open door. Doing so can result in serious injury or cuts. 7. Position dishwasher in its finished installation position. Secure mounting brackets to the floor. Recommend using lag screws purchased locally. 8. Reinstall dishwasher per dishwasher installation instructions. 9. Install access panel by reversing steps 1 and 2.
PAGE 3
FEUILLE D’INSTRUCTIONS pour la trousse de fixation sur le plancher du lave-vaisselle wAVERTISSEMENT Risque de choc électrique Déconnecter la source de courant électrique avant l’entretien. Replacer tous les panneaux avant de faire la remise en marche. Le non-respect de ces instructions peut causer un décès ou un choc électrique. La trousse contient : 2 Supports de fixation 1 Feuille d’instructions NOTA : Les vis de fixation sur le plancher ne sont pas fournies; elles doivent être achetées localement. 4.
PAGE 4
wAVERTISSEMENT Risque de basculement Ne pas utiliser le lave-vaisselle jusqu’à ce qu’il soit complètement installé. Ne pas appuyer sur la porte ouverte. Le non-respect de ces instructions peut causer des blessures graves ou des coupures. 7. Positionner le lave-vaisselle dans sa position d’installation finale. Faire tenir les supports de fixation sur le plancher. Il est recommandé d’utiliser des tire-fond que l’on achètera localement. 8.