user manual

16
CODE EXPLANATION
COIN SLIDE OPTION
This option is either SELECTED ‘ON’ or NOT SELECTED ‘OFF’.
Replacement of metercase will be needed for coin slide mounting.
Not Selected ‘OFF’.
Selected ‘ON’.
NOTE: This option needs to be set to ‘00’ unless the
metercase has been changed to accept a coin slide device.
Press DELICATES button 3 consecutive times for this
selection. When coin slide mode is selected, set ‘b.’ equal to
value of slide in coins. Set ‘6 xx’ (REGULAR CYCLE PRICE)
and ‘3.xx’ (SPECIAL CYCLE PRICE) to number of slide
operations. 6 01 & 3.01 = 1 slide push.
NOTE: If the installer sets up ‘CS’ on a coin drop model,
it will not register coins.

Press PERM. PRESS button once to advance to next code.
ADD COINS OPTION
This option is either SELECTED ‘ON’ or NOT SELECTED ‘OFF’.
This option causes the customer display to show the number
of coins (coin 1) to enter, rather than the amount.
Not Selected ‘OFF’.
Selected ‘ON’.
Press DELICATES button 3 consecutive times for this selection.
PN MODELS: This option is not selectable.

Press PERM. PRESS button once to advance to next code.
COIN/DEBIT OPTION
Both coin & debit selected. (NOT AVAILABLE)
Coins selected, debit disabled.
Press DELICATES button 3 consecutive times for this selection.
Debit Card selected, coin disabled. Default for PN models,
and for PN operation, must be set as J._d.
Press DELICATES button 3 consecutive times for this selection.
Enhanced Debit is self-selected when a Generation 2 card
reader is installed in the dryer. The ‘Ed’ option cannot be
manually selected or deselected. (NOT AVAILABLE)

Press PERM. PRESS button once to advance to next code.
PRICE SUPPRESSION OPTION
This option is either SELECTED ‘ON’ OR NOT SELECTED ‘OFF’.
This option causes the customer display to show ‘AVAILABLE’
or ‘ADD’ rather than the amount of money to add. (Used
mainly in debit installations.)
Not Selected ‘OFF’.
Selected ‘ON’. Press DELICATES button once for this selection.

Press PERM. PRESS button once to advance to next code.
CLEAR ESCROW OPTION
This option is either SELECTED ‘ON’ OR NOT SELECTED ‘OFF’.
When selected, money held in escrow for 30 minutes without
further escrow or cycle activity will be cleared.
Selected ‘ON’.
Not Selected ‘OFF’. Press DELICATES button once to deselect
this option.

Press PERM. PRESS button once to advance to next code.
HUNDREDTH INCREMENT OFFSET
This represents the hundredth increment price offset used
in Generation 2 (Enhanced Debit) PN models set up with card
reader. Choose from 0-4 hundredths by pressing the WHITES
AND COLORS button. (NOT AVAILABLE)

Press PERM. PRESS button once to advance to next code.
8.00
E . 0 0
E . 0 0
E . AC
8.00
8. CS
J . C 8
L . 0 0
L . 0 0
L . PS
J . C 8
J . C 8
J . C 8
J . E 8
8. CE
8. CE
8.0 0
0. 0 0
0. 0 0
If cycle counter (9 0C) is selected, the following is true:
1 00 Represents the number of cycles in HUNDREDS. 1 02
= 200
2 00 Represents the number of cycles in ONES. 2 25 = 225
TOTAL CYCLES = 225
This is ‘VIEW ONLY’ and cannot be cleared.
Press the PERM. PRESS button once to advance
to next code.
If money counter (1.0C or 1.C0) is selected, the following is true:
3 00 Currency amount in HUNDREDS. 3 01
= 100.00
4 00 Currency amount in ONES. 4 68
= 168.00
5 00 Currency amount in HUNDREDTHS. 5 75 = 100.75
TOTAL = 168.75
END OF SET-UP PROCEDURES
EXIT FROM SET-UP MODE
■
PD MODELS: Reinstall access door.
■
PN MODELS where AA1 plug was removed:
1. Unplug dryer or disconnect power.
2. Open console, reinsert jumper into AA1, close console.
3. Plug in dryer or reconnect power.
■
PN WITH PROGRAMMING SWITCH: Turn key clockwise and
remove.
■
If Service Access Code was used to enter set-up mode: From
Set-up Code 8, press button #1 for 4 seconds, wait 2 minutes
without touching any buttons (without diagnostic modes running),
or power down the dryer, then reapply power.
EU - DECLARATION OF CONFORMITY
CE - DECLARATION DE CONFORMITE
WE (nous): BAUKNECHT HAUSGERÄTE GmbH, D-73614 Schorndorf
representing (représentant): WHIRLPOOL EUROPE S.r.l I-21025 COMERIO
declare under our sole responsibility that the product
déclarons sous notre propre responsabilité que le produit
dryer Maytag MDG22PD
(sèche-linge) :
Maytag MDG22PN
to which this declaration relates is in conformity with the following standard(s) or other
normative document(s)
auquel se référe cette déclaration est conforme aux normes suivantes ou autres documents normatifs
EN 60335-1:2002+A1+A2+A11+A12+A13
EN 60335-2-11:2003+A1+A2
EN 12752-1:1999
EN 62233:2008
EN ISO 10472-1:2008
EN ISO 10472-4:2008
EN 55014-1:2006
EN 55014-2:1997+A1 :2001
EN 61000-3-11:2000
EN 61000-3-12:2005
following the provisions of Directive(s):
suivant les prévisions des Directives :
2009/142/EC EUROPEAN GAS APPLIANCE DIRECTIVE
2006/95/EC LOW VOLTAGE DIRECTIVE (CEE Directive Basse Tension)
2004/108/EC ELECTROMAGNETIC COMPATIBILITY DIRECTIVE (CEE Directive Compatibilité
Electro-magnétique)
2006/42/EC MACHINERY DIRECTIVE
represented by
Schorndorf, 29.04.2010 Roberto Mottura
Place and date: Director PDC, FC
lieu et date :
Name and signature of authorised person
Nom et signature de la personne autorisée