user manual

4
Location Requirements
If installing a gas dryer:
IMPORTANT: Observe all governing codes and ordinances.
Check code requirements: Some codes limit or do not permit
installation of clothes dryers in garages, closets, or sleeping
quarters. Contact your local building inspector.
Make sure that lower edges of the cabinet, plus the back and
bottom sides of the dryer, are free of obstructions to permit
adequate clearance of air openings for combustion air. See
“Recessed Area and Closet Installation Instructions” below
for minimum spacing requirements.
Do not install on carpet.
NOTE: The dryer must not be installed in an area where it will be
exposed to water and/or weather.
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed:
200 mm (8") or 250 mm
(10") Pipe wrench
200 mm (8") or 250 mm
(10") Adjustable wrench
Flat-blade screwdriver
Phillips screwdriver
Adjustable wrench that
opens to 25 mm (1") or
hex-head socket wrench
Level
8 mm (
5
/16") socket wrench
Utility knife
Vent clamps
Pipe-joint compound
resistant to LP gas
Sealing gun and sealing
compound (for installing
new exhaust vent)
Pliers
Stiff-bladed putty knife
Parts supplied:
Remove parts bag from dryer drum. Check that all parts were
included.
Foot boot (4)
Dryer foot (4)
PD models: Cam for
service door lock
PN models: Card reader
bezel, card reader wire
harness, hardware
DRYER DISPOSAL
NOTE: The circuit diagram for this dryer is located inside the
lower front panel, within the Tech Sheets.