Manual

BEFORE YOU CALL FOR SERVICE
Cheek these points if...
Part or all of your wall oven does not
operate
• Is the wail oven plug loose or disconnected
from the electrical outlet (if not w_red direct
to the electrical supply)?
• Are any house fuses blown or circuit
breakers tripped?
• Has a wall oven fuse blown (Canadian wall
ovens only)?
• Has the power supply to the home been
interrupted?
• Are the oven controls properly" set?
• Was the electronic control correctly, set?
• Was the door left in the locked position
following a self-clean cycle?
• Is the oven set for delay start?
Food not baking correctly
" Are the oven racks properly' placed for
baking? (see Baking Chart)
- Have you used aluminum foil correctly?
• Was the oven preheated as recommended?
• Are the controls for bake operations
properly set?
• Is there 1 to 2 inches of space between pans
and the oven walls? Are the wall oven and
oven racks level?
• Was good cookwareibakeware of the proper
size used?
• Are you using a tested recipe from a reliable
source? The oven thermostat on your new
wall oven may be more accurate than the
one on your old wall oven.
- Was the oven vent covered or blocked on
the wall oven surface?
Food does not broil properly
* Are the controls for broiling set properly?
(see Broiling section)
• Was the proper rack position used? (see
Broiling section)
• Did you allow time for the broil element to
preheat?
- Was the broiler pan received with the wall
oven used?
, Was aluminum foil used on the broiler pan
insert, blocking the slits for fat drainage?
Oven light does not operate
• Is the bulb Ioose or burned out?
* Is the light switch in the On position?
Oven will not self-clean
• Is the self-clean control set properly? (see
Self-Clean instructions)
• Is the oven set for delay start?
Oven door won't latch
• Are the proper controls set for the self-clean
cycle? (see Self-Clean instructions).
Oven door will not unlock
• Has the self-clean cycle been finished for at
least one hour?
"F" plus a number appears in the display
• These are fault codes. If a fault code appears
in the display and a continuous beep sounds,
press the CANCEL button. If the fault code
reappears, disconnect power to the wall
oven and call a qualified service technician.
PAGE 18