Manual

Maintaining the Dishwasher To Change Panels:
The interior is normally self-cleaning. A. Remove three screws holding the chrome
Occasionally check the bottom of the dishwasher trim strip on one side of the door. Take note
tub and clean out pieces of food which may of how the trim crones off.
collect there. B. Grasping the lower part of the door panels,
Periodically" clean the bottom edge of the bow panels out carefully at the bottom while
dishwasher door liner. Food and liquids drip sliding panels far enough to clear the flange
onto this area when tile dishwasher is loaded, on the trim strip which was not removed and
If you notice an odor in your dishwasher, it may" remove panels.
be due to a strong "chemical" or chlorine odor C. Arrange panels so the desired color is
from the dishwasher detergent. Using a different facing out.
detergent, especially a lemon scented one, wiU
D. Place door panels (notched side up) behind
probably eliminate the odor. In some instances tile chrome trim at ti_e bottom of tile door.
the smell of the rinse additive may be strong. Bow the panels so they fit behind the control
Purchase a fresh package and see if it is better, panel at the top.
Lastly, if the dishwasher is rnn only every couple
of days, an odor may develop. Use the Rinse & E. Slide the panels under the side chrome trim
Hold feature daily to remove any food soil that which was not removed. To do this, it will be
]nay cause an odor. necessary to compress the baetdng behind
the colored panels.
To remove an odor, try one of the followiug:
E Reinstall the chrome trim which was
1. Place baking soda in both sides of the removed earlier. To do this, start by inserting
detergent dispenser. Select Light/China and the tip end of the trim strip behind the
let the water circulate for about 10 minutes, control panel, Align the holes and replace the
Stop the dishwasher by unlatching the door three screws.
and let stand overnight. Then, restart the
dishwasher by latching the door and let it G, The lower access panel is held by four screws
complete the cycle. (two above the panel and two below). With
these removed, the panel ]nay be removed to
2. Select the Light/China cycle and let the make it easy to change panel colors.
dishwasher t?fllwith water. Then open the
door and pour one cup of chlorine bleach into H. With the lower aceess panel removed,
the bottom of the dishwasher. Latch the door remove the four screws along the bottom of
and let the dishwasher complete the cycle, panel and remove the trim whieh holds tile
panels. Once the desired panel is facing out,
Clean the control panel and front panel with a replace the trim, and reinstall the panel to
soft clamp cloth and liquid spray"cleaner. Do not the dishwasher.
use any abrasive powders or cleaning pads.
Use care when changing panels to be certain you
are not injured on sharp edges and that the
Changing Panels panels are not damaged. If you have any
Your Maytag dishwasher comes with reversible questions concerning changing panels, contact
panel inserts which are pre-assembled at the your local Maytag Dealer.
factory. This enables you to select the color you Accessory panels are available in some additional
want before your dishwasher is installed or colors. Also, a kit is available to customize your
choose another color at a later date. dishwasher. See your local Maytag Dealer for
details.
PAGE 13