User`s guide

Instructions for Installation (cont'd)
Standard Vent Kit (cont'd)
9. Place the water heater at the opening in the wall, at the 12. We have supplied 4 wood screws to temporarily attach the
predetermined clearance, collar to the exterior wall of the building. However, other
types of screws may have to be substituted depending on
\\
\\
\\ 13. Insert the 3" diameter flue extension pipe into the vent
\\ collar assembly (flared & notched end first) and lock (turn
'\ \
clockwise to lock studs to slots) the flue extension pipe to
\\ _ _ the flue elbow.
\\
10. Move outdoors with all the remaining vent parts. Using _ ..... _ ....
the tube of seal.ant supplied, run an ample amount on the :: ....
inside surface of the collar assembly that will contact the
exterior wall and also fill the bead on the end of the 6"
diameter vent collar.
__ 14. Connect the vent cap by sliding its end over the 3" diame-
ter extension pipe and O-ring.
NOTE: To facilitate ease of assembly of the vent cap to
the 3" pipe, a soap solution can be applied to the O-ring
gasket.
11. In:t tallt:htheVenteCOsUo_na:sTolz_yeltbho_u(ghe;ehediwa_g,oCOnh_:h VJ_/////_
16