User`s guide

Instructions for Installation (cont'd)
15. The vent cap has 4 holes around the outer edge. Remove
the 4 screws used to temporarily attach the collar to the
exterior wall. Then secure the vent cap assembly with the
vent collar assembly to the exterior wall using the same 4
screws.
NOTE: Screws are suppfied; however, substitution may
be necessary depending on the exterior wall material.
A CAUTION
To prevent unlocking the previouslyinstalled 3" diameter
extension, the vent cap assembly must be rotated in a
cockwise mot on when the vent cap s nsta ed.
OW/_ihO_(/n_er _idca/oVre22K ia_
Any Optional Vent Kit
16. Go back indoors to attach inside collar to the inside wall.
Place the collar against the wall. Secure to wall by using 4 _ _
long sheet metal screws.
U
U
NOTE: Screws are supplied; however, substitution may
be necessary depending on the interior wall material.
The opening through the wall should be cut at this time. If it
hasn't been, refer back to that section.
1. First it must be determined how far the vertical (3" dia.)
telescoping flue sections are set and locked together using
the two screws supplied as shown below.
I
17. Using the tube of sealant supplied, run an ample amount II I
of sealant around the edge of the vent pipe where it is ____
inserted through the inside collar to seal air drafts from
wall.
17