User`s guide

Instructions for Installation (cont'd)
7. Place the 3" elbow on the flue extension.
10. If"E" Dimension is less than 61/2# move to next step.
NOTE: Make sure elbow is properly aligned to opening If "E" dimension is over 6V:', assemble the 6" diameter
in the outside wail. extension pipe to the 6" diameter vent elbow and secure
Mark the 3" dia. end of the flue extension at the slots the using two sheet metal screws. Using the tube of sealant
elbow. Using a #22 drill bit, drill holes into the flue exten- supplied, run an ample amount around the joint to insure
sion at the two slots and secure the elbow to the flue a good seal.
extension using the screws provided.
__t_o!s, _[ ___
3.1.Slide the vent collar (to be installed later) over the 6" vent
8. Making sure the 6" diameter elbow is centered around the
elbow.
ure " "
3" diameter flue, sec the 6 diameter vent pipe using
two sheet metal screws at the connection of the elbow and
6" vertical extension.
12. Place the water heater at the opening in the walI, at the
predetermined clearance.
9. The standard vent kit [_J[
includes a 6# diameter
extension pipe which is _1
used when "E" dimension ,_
over 6V:'.
\\
-
19