User`s guide

Instructions for Installation (cont'd)

Optional Vertical Vent Kit

(cont'd)

13. Move outdoors with all the remaining vent pans. Using the 16. Insert the 3" diameter flue extension pipe into the vent

tube of sealant supplied, run an ample amount on the inside collar assembly (flared &. notched end first) and lock (turn

surface of the collar assembly that will contact the exterior clockwise to lock studs to slots) the flue extension pipe to

wall and also fill the bead on the end of the 6" diameter vent the flue elbow.

collar.

17. Connect the vent cap by sliding its end over the 3" diame-

ter extension pipe and O-ring.

14. Install the vent collar assembly through the wall, connect- NOTE: To _¢ili_ate ease of _ssembly of the vent cap to

ing it to the extension and/or elbow (depending on which the 3" pipe, a soap solution can be applied to the O-ring

one was used), gasket.

15. We have supplied 4 wood screws to temporarily attach the 18. The vent cap has 4 holes around the outer edge. Remove

collar to the exterior wall of the building. However, other the 4 screws used to temporarily attach the collar to the

types of screws may have to be substituted depending on exterior wall. Then secure the vent cap assembly with the

the construction of the external wall. vent collar assembly to the exterior wall using the same 4

screws.

A CAUTION

j__41/ /TOprevent unlocking the previously installed 3" diameter

I extension, the vent cap assembly must be rotated in a

[ clockwise motion when the vent cap is installed.