User`s guide

Instructions for Installation (cont'd)

Optional Horizontal Vent Kit

Installation #3

19. Go back indoors to attach inside collar to the inside wall. Any Optional Vent Kit

lottgPlacethecollaragainstthewaU.SecuretowaUbyusing4sheetmetaJ, screws. ___ _

NOTE: Screws are supplied; however, substitution may

be necessary depending on the interior wall material. _ _

These _

parts are

not used

*Each part is stamped with a part number

The opening through the wall should be cut at this time. If it

hasn't been, refer back to that section.

1. Lock the elbow to the straight 3" flue pipe. Set the assem-

bly in place on the end of the water heater's flue collar.

20. Using the tube of sealant supplied, run an ample amount

of sealant around the edge of the vent pipe where it is =,_

inserted through the inside collar to seal air drafts from ._ _ __

wall.

2. Mark the flue collar at the slots in the elbow. Using a #22

drill bit, drill holes into the flue collar at the two slots and

secure the elbow to the flue collar using the screws provided.

NOTE: Make sure elbow is properly aligned to opening

in the outside wall.