User`s guide

Instructions for Installation (cont'd)
Optional Horizontal Vent Kit
(cont'd)
15. The vent cap has 4 holes around the outer edge. Remove 18. Using a #22 drill bit, drill holes 180 ° apart at the connec-
the 4 screws used to temporarily attach the collar to the tion point of the two 3" flue extensions. Then using 2
exterior wall. Then secure the vent cap assembly with the screws provided, lock these pipes together.
vent coUarassembly to the exterior wall using the same 4
screws.
NOTE: Screws are supplied; however, substitution may i _tt[.
be necessary, depending on the exterior wall material. /_ I
i
19. Now the 6" vent extension pipes can be expanded to con-
nect at the vent elbow.
16. Move indoors to complete the assembly process.
17. Collapse the 6" flue extension assembly as shown below j_/A,_//
and install the 3" extension by first slipping the end with
the O-ring approximately 1V," into the end of the vent
cap. Lock the other end of the 3" extension to the studs in
the elbow.
NOTE: To facilitate ease of assembly of the vent cap to
the 3" pipe, a soap solution can be applied to the O-ring
gasket.
20. Pull the vent collar from the elbow to be against the wall
and secure it using the screws provided.
24