User`s guide

Instructions for Installation (cont'd)
Optional Vertical and
Horizontal Vent Kits (Cont'd)
the tube of sealant supplied, run an ample amount on the / // /
inside surface of the collar assembly that will contact the • , s _ _ i
exterior wall and also fiLlthe bead on the end of the 6" ////7 _ /7"x
diameter vent collar, t /
It I
_\ /
/ / 7.?/_--_/-2/L',-- i
N"_}l_/_// / 17. Place the vent cap in the vent collar assembly.
15. Install the vent collar assembly through the waU, connect-_'/_//7_
ing it to the 6" telescoping extension. Remember, the
extension is not connected yet and it may be necessary to _/'//_7//_
go back indoors and push it back up for a tight fit to the
COllar.
18. The vent cap has 4 holes around the outer edge. Remove
I_/?__ the 4 screws used to temporarily attach the collar to the
k/_/_/#/_##__ exterior waU. Then secure the vent cap assembly with the
[l vent collar assembly to the exterior wall using the same 4
• screws.
NOTE: Screws are supplied; however, substitution may
be necessary, depending on the exterior wall material.
collar to the exterior wall of the building. However, other
types of screws may have to be substituted depending on
the construction of the exterior wall.
19. Move indoors to complete the assembly process.
28