Installation manual

• j• •

i ,

Check these points if your washer...

• Unevenly distributed load. Redistribute the load, close the lid and pull knob :

out. Check for leveling. Be sure water level is acceptable for load size.

• Plug cord into live electrical outlet.

• Check fuse or reset circuit breaker. :

• Turn the control knob to proper cycle and pull knob out to start the washer. If

Stops equipped with buttons, be sure they are fully depressed.

• Close lid and pull knob out to start the washer. For your safety, washer will

not agitate or spin unless lid is closed.

• This may be a pause or soak period in the cycle. Wait briefly and it may start.

• The washer is equipped with a lid switch failure detector. If the lid switch

should malfunction, the detector will stop fill operations for your safety. Call

for service.

ooo* ooe** eeo*** bocce. ,,,,*. 6t.,,, ,,,e* *tee, 6eoe, .,,, ,,,e ,,,e• ,,tle,. eloe, O*Oe* leeeO I*eoe* Oleeeoo* OOOe* elO*OO eloe*e* O***OOe e*ee*

• Make sure hose connections are tight.

• Make sure end of drain hose is correctly inserted and secured to drain facility.

Leaks Water

• Avoid extended soaking - soak for 30 minutes or less.

• Avoid overloading.

*o,.... o••,ee.•. •,,eo*, *t•,,,. ,,ee*., eee,, oo.oe ee, eee, ,,e ,,e_ ,,,..** ,** ,O* OeO** COO,, OOlee*O e*OO*O, eOOO*e* •O*OeOe e*•eoQ*e •••e* O•

• Be sure washer is leveled properly as outlined in installation manual.

• Weak floors can cause vibration and walking.

Is Noisy • Be sure rubber feet are installed on leveling legs.

• Be sure locking nuts on legs are tight.

,coo,. teee.e • 60,eoe,l*** o*•• l*** ••• •**** e*•, e**•• oo••• co••• •

• e o•• • *** ._oo,,, oeeeoe_ .*oo.•..e oeeeeeo ._ooo,• 6oto.. teoe,, eee,. .,,,.

• Turn both faucets on fully.

Fills with • Check temperature push button to be sure it is depressed completely.

the Wrong • Make sure temperature selection is correct.

Temperature • Make sure hoses are connected to correct faucets and inlet connections. Be

Water sure water supply is regulated correctly. Flush water line before filling washer.

• Check the water heater. It should be set to deliver a minimum 120°F (49°C)

hot water at the tap. Also check water heater capacity and recovery rate.

• Disconnect hoses and clean screens. Hose filter screens may be plugged.

• Check to see if the "Energy Saver" option is selected. If it is selected, press

"Normal Temp".

.. oeeeo .o*e. , o•***o_ ••oe*•** e•ee*_ ee••eo _••ee•, e*_•ee*e *_•eeo _*•••_o •e***

Cycle Selector

Knob Advances • Extra rinse option is selected

Through "OFF"

Forfurther assistance contact MaytagAppliances Sales Company, Maytag CustomerAssistance:

U.S. 1-800-688-9900or Canada 1-800-688-2002