User's Manual

G
G - 9
ELEcTRIcAL SySTEM
SATELLITE ANTENNA WIRING
If you compare the two previous drawings you’ll see
wiring for a satellite dish antenna is relatively simple.
Units have a faceplate with two coax cable hook-ups.
It is located in the TV credenza on all models except
the slide-out model with the overhead TV, which is
located in the cabinet to the roadside of the TV. The
faceplate has a small coax cable jumper running
between the hook-ups to complete the cable TV
circuit when in use. To install a satellite system use
the following procedure:
1. Remove the jumper wire from the coax faceplate.
2. Hook a portable dish into the Cable TV receptacle in
the roadside rear underbelly compartment. This feeds
the dish signal to the input side of the faceplate.
3. Install the satellite receiver input and output into the
dual coax faceplate.
To return to a cable TV system, remove the satellite
receiver from the faceplate and reinstall the
jumper cable.