User's Manual

G
ELEcTRIcAL SySTEM
G - 10
SOLAR PANEL PRE-WIRE
Airstream Travel Trailers are pre-wired for an
Intermountain Solar Technology Solar Panel/Chare
Controller/Display System. This system may be in-
stalled on your trailer as an option. A manual on the use
of the system is included with the Airstream Owner’s
Blue Delivery Case.
Intermountain Solar Technologies
10288 South Jordan Gateway #D
South Jordan, UT 84095
800-671-0169
1. YELLOW (like the sun) positive and GREEN (like the
earth) negative leads runs from battery breaker buss bar
area to a harness inside the exterior refrigerator access
door. The battery buss bar is located behind the sofa
on front lounge models or behind the front cabinets on
slide outs, and next to the battery compartment. Battery
cables will run to this bar. Roof mounted panels require
dropping the panel wires down through the refrigerator
vent to the inside of the exterior refrigerator access
door. Portable solar panels can be set outside close
to the access door. The wires from the solar panel are
connected to the positive and negative wires (yellow
and green) of the pre-wire system.
2. A Cat 5 patch cord for the solar panel display runs
from the battery buss bar to an area just below the
CatCon seven display. The solar panel display panel
can be mounted just below the CatCon monitor panel
by routing the proper size hole. The Cat 5 wire is
plugged into the display panel.
CAUTION: The Yellow wire must be fused with a
10-amp in-line fuse at the 12-volt positive.
NOTE: All wires are identified with labels at
all locations.
The Intermountain solar panel has charge controller
that should be mounted close to the battery buss bars
as the battery leads are hooked into it to sense the
actual battery charge. The Cat 5 wire plugs into it also.
The following drawing is the way Airstream wires the
system on factory installed units and is the recom-
mended wiring for use of the pre-wire system.