Use & Care Guide

Sanitizes dishes and glassware by raising water
temperature in final rinse. In accordance with NSF/ ANSI
Standard 184 for Residential Dishwashers. Certified
residential dishwashers are not intended for licensed food
establishments. This option will add heat and time to cycle.
At end of the cycle, the sanitized indicator (or word
“sanitized” on some models) will glow. If your load did not
properly sanitize, the indicator will flash at the end of the
cycle. This can happen if cycle is interrupted, or if the water
does not reach the required temperature. The light goes off
when you open and close the door or press CANCEL.
Auto
PowerBlast™
Normal
Increased main
wash temperature
from 105°F (41°C)
to 145°F (63°C)
and final rinse from
140°F (60°C) to
156°F (69°C).
:04 to 1:15 0 - 3.0
(0 - 11.2)
Dries dishes with heat. Use option with rinse aid to provide
best drying results. Plastic items are less likely to deform
when loaded in top rack. Turn option off for an air dry.
Auto
PowerBlast™
Normal
Quick
Uses heating
element to speed
drying times.
:29 to:46 0
OPTIONS CAN BE
SELECTED
WITH
WHAT IT DOES ADDED
TIME TO
CYCLE
ADDED
WATER
GALLONS
(LITERS)
B
A
C
CONTROL PURPOSE COMMENTS
Press to start
or resume a
wash cycle
If the door is opened during a cycle or power is interrupted, Start/Resume indicator flashes. Cycle will
not resume until door is closed and Start/Resume is pressed.
NOTE: If START/RESUME button is located on top of door, push door firmly closed within 4 seconds
of pressing START/RESUME. If door is not closed within 4 seconds, start button LED will flash, an
audible tone will be heard (on some top control models), and cycle will not start.
Press to
cancel wash
cycle
Close door firmly. The dishwasher starts a 3-minute drain (if needed). Let dishwasher drain
completely.
Control Lock
avoids
unintended
use of
dishwasher
between
cycles, or
cycle and
option
changes
during a cycle.
To turn on Lock, press and hold CONTROL LOCK or SANITIZE (depending on model) for 3 seconds.
Control Lock light will stay on for a short time, indicating that it is activated and all buttons are
disabled. If you press any button while your dishwasher is locked, light flashes 3 times. Dishwasher
door can still be opened/closed while controls are locked.
To turn off Lock, press and hold CONTROL LOCK or SANITIZE (depending on model) for 3 seconds.
Light turns off.
NOTE: If your model requires you to press and hold SANITIZE to lock controls, Control Locked
LED(C) will be on or off to indicate whether Control Lock is active or not.
indicator light
To follow the
progress of
your
dishwasher
cycle
Depending on your model, progress will be displayed by a full lit display or by an indicator light on the
front panel.
The full lit display will glow for wash (A), dry (B), sanitized or clean. It will also show the estimated
remaining time for the cycle.
The indicator light will glow blue for wash, red for dry, and green for cycle complete.
B
A
C
B
A
C