Installation guide

Connect drain hose
Connect drain. hose to waste tee or waste. disposer
using one of the following options:
* Option A, Waste disposer - no-air-gap
«Option B, No Waste disposer -no airgap
«Option C, Waste disposer -.with air.gap
* Option 'D, No waste disposer - with air.gap
IMPORTANT: The drain hose connection of the disposer or
a waste tee must be made before the drain trap and at
least 20" (50.8 cm) above the floor where the dishwasher
will be installed.
Helpful Tip: To reduce vibration of the hose, keep the hose
away from the floor.
Option A, Waste disposer - no air gap
Waste disposer —no air gap
“La rge silver.
Disposer inlets.
drain hose clamp.
Drain hose
Drain trap
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Attach drain hose to disposer inlet
with large silver drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
Large silver .
drain hose clamp ™~
Drain hose
1. Connect black end of of drain hose to
waste tee and cut if needed.
(Do not cut ribbed section.)
2. Attach black end of drain hose to waste
tee with a large silver drain hose clamp
(provided). Use pliers to squeeze clamp
open and move into position. If the drain
hose was cut, use a 144" to 2" (3.8 to
mee 5 cm) screw-type clamp (not provided).
Option C, Waste disposer - with air gap
Waste disposer — with air gap | ..
<Serew-type clamps Large silver drain
i hose clamp _
Rubber hose
connector
Drain hose
. [ Drain trap
&
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Connect black end of drain hose to air
gap and cut if needed. (Do not cut
ribbed section.)
4. Attach drain hose to air gap with large
silver drain hose clamp (provided).
Use pliers to squeeze clamp open and
move into position. If the drain hose
was cut, use a 1%" to 2" (3.8 to
5 cm) screw-type clamp (not
provided).
5. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from air gap to disposer inlet.
SS Air gaps
Large silver PaaS .
hose clamp s
Rubber hose
connector
Drain hose
1. Connect black end of drain hose to air
gap and cut if needed. (Do not cut
ribbed section.)
2. Attach drain hose to air gap with large
silver drain hose clamp (provided).
Use pliers to squeeze clamp open and
move into position. If the drain hose
was cut, use a 14%" to 2" (3.8 to 5 cm)
screw-type clamp (not provided).
3. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from waste tee to air gap.