Installation guide

Wiring configuration
Power supply wire: Terminal box wire:
white ~<——> white
black ~«——» black
ground wire ~«———»- ground connector
If needed, see website for animated representation of
this step. Visit www.maytag.com under FAQ tab.
Power cord - Secure cord
on conduit connector
Tighten strain relief screws to secure cord.
Power Cord—Reinstall
terminal box cover
Place wires inside terminal box. Insert tabs on left side
of cover. Make sure wires are tucked inside box. Close
cover ensuring wires are not pinched. Use 14" nut driver
and previously removed screw to secure cover.
NOTE: Do not plug into outlet until instructed to do so.
Determine Cabinet Opening
1 | Measure cabinet opening
@
\
LY
Li
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed
(you will need to measure the lowest point on the
underside of the countertop and the highest point on the
floor). Refer to “Dishwasher Height Adjustment Chart”
for wheel position and the number of turns needed.
Dishwasher Height Adjustment Chart
Cabinet Wheel Number of turns
opening height position on-front leg
337%".(86.0.cm) remove All the way up
34" (86.4 cm) 1 10
3414" (87 cm) 2 5
3414" (87.6.cm) 3 0 J
NOTE: If the minimum cabinet opening height is less than
34"(86.4 cm), the rear wheels can be removed for
additional clearance. This will allow the dishwasher to fit
into a 33 %" (86 cm) high cabinet opening, but the
dishwasher will be more difficult to move. (Measurements
are approximate. Wheels and legs are preset at the
factory for 3414" [87.6 cm].)
2 | Adjust wheels and legs
int
ee
SS
DE
:
Turn both leveler legs to the same height. Put wheels in
the required position determined from “Dishwasher
Height Adjustment Chart.”
13