Installation guide

Q | Check for plumb and
adjust legs if needed
SS eS S
Check that leveling legs are firmly against the floor.
Close and latch the door, and place level against the
front panel. Check that dishwasher is centered from front
to back in the opening. If needed, adjust leveling leg until
dishwasher is plumb. Repeat for other side of dishwasher.
Helpful Tip: Push up on front of dishwasher to raise
dishwasher off the ground to adjust front legs. With
some installations, it may be easier to adjust the front leg
using the %s" hex head socket or adjustable wrench.
Preferred method Optional method
Check level side to side and
adjust legs if needed
Place level against top front opening of tub. Check that
dishwasher is level from side to side. If dishwasher is not
level, adjust front legs up or down until dishwasher is
level.
Connect to Water Supply
1 | Tighten 90° elbow fitting to valve
Be sure rubber washer is properly seated in fitting. Slide
the %" fitting up to the valve and hand-tighten to avoid
unintentional cross-threading. Hand-tighten until the
coupling is tight. Using pliers, check the tightness of the
coupling. An additional 4 to 4% turn may be required to
seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can
result.
2 | Check for leaks
Place paper towel under 90° elbow fitting. Turn on water
supply and check for leaks. If leak occurs, repeat
previous step.
17