Installation guide

Connect
to
Drain
3
|
Hose
clamp
final
position
1 | Connect drain hose
Green clamp
Black drain hose
Black drain hose
connector
Drain
hose
connector
Drain hose stop
Stop
Stop
Place towel under drain hose to catch any water in drain
After hose is connected, remove towel.
hose. Place the small green drain hose clamp onto the
small end of the drain hose. Push the new drain hose If needed, see website for animated representation of
into the black drain hose connector up to the drain hose this step. Visit www.maytag.com/drain under FAQ tab.
stop.
Make Direct Wire Electrical
Connection
NOTE: If the power supply cord was connected earlier
proceed to “Secure Dishwasher in Cabinet Opening”
section.
Option B, Direct Wire:
Slide clamp onto connector
Green clamp
Black drain hose
connector
a
Vy,
Drain hose
1 Direct Wire—Route cable
into terminal box
Drain hose stop
Stop
Using pliers, squeeze open the small green drain hose
clamp and slide onto connector between stops.
Route cable so that it does not touch dishwasher motor
or lower part of dishwasher tub. Pull cable through cable
clamp in terminal box.
Select UL listed or CSA approved twist-on wire connectors
(not included) rated to connect your household wiring to
16-gauge dishwasher wiring.
18