Installation guide

sher
AWARNING
Option D, No waste disposer — with air gap Prepare Dish
No waste disposer - with air gap
p- Largé blue drain
hose clamp ™
Rubber hose
connector
Tip Over Hazard
Do not use dishwasher until completely installed.
Drain hose
Do not push down on open door.
ce
COIS,
Doing so can result in serious injury or cuts.
1. Connect rubber end of drain hose to
air gap and cut if needed.
NOTE: Do not cut ribbed section. I Wed I Ce
Excessive Weight Hazard
2. Attach drain hose to air gap with
large blue drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position. Failure to do so can result in back or other injury.
lf the drain hose was cut, use a 11%”
to 2" (3.8 to 5 cm) screw-type clamp
(not provided).
Use two or more people to move and install
dishwasher.
3.
Use
a
rubber
hose
(not
provided)
1
Remove
foam
block
with
screw-type
clamps
(not
OR
provided)
to
connect
from
waste
tee
;
to
air
gap.
Foam-block
Remove and discard the foam blocks located above the front legs
on each side of the dishwasher. The blocks cover the rope/link
pulleys on the dishwasher.
Helpful Tip: Place cardboard under dishwasher until installed in
cabinet opening to avoid damaging floor covering. Do not use
door panel as a worktable without first covering with a towel to
avoid scratching the door panel.
11