Installation guide

Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors (not included).
Wiring configuration
Power supply wire: Terminal box wire:
white <<—>> white
black ~<«—_——»- black
ground wire «<———» ground connector
If needed, see website for animated representation of this step.
Visit www.maytag.com/electrical under FAQ tab.
4 | Direct Wire—Secure cable
-— in strain relief
Tighten strain relief screws to secure cable.
Direct Wire—Reinstall
terminal box cover
B
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use 4" nut driver or Torx® T20® screwdriver
and previously removed screw to secure cover.
Secure Dishwasher in Cabinet Opening
Double-check dishwasher
alignment in cabinet opening
Check that dishwasher is still level front-to-back and side-to-side
in cabinet opening.
Remove lower dish rack
and place towe
OT
Open dishwasher door, remove lower dish rack, and place towel
over pump assembly and lower spray arm of dishwasher. This will
keep screws from falling into pump area when you are securing
the dishwasher.
3 | Secure dishwasher
Sey
“Screw to
side cabinet
NOTE: Do not drop screws into bottom of dishwasher.
21