Installation guide

1. Fit rubber end of drain hose to waste
tee and cut if needed.
NOTE: Do not cut ribbed section.
Connect drain hose
Connect drain hose to waste tee-or waste disposer
using one of the following options: 2. Attach rubber end of drain hose to
waste tee with a large blue drain
hose clamp (provided). Use pliers to
squeeze clamp open and move into
position. If the drain hose was cut,
use a 1%" to 2" (3.8 to 5 cm) screw-
type clamp (not provided).
* Option A, Waste disposer —no air-gap
« Option B, No waste disposer — no air gap
* Option C, Waste disposer — with air gap
« Option D, ‘No waste disposer —with air gap
IMPORTANT: The drain hose connection of the disposer or a
waste tee must be made before the drain trap and at least : : —
20" (50.8 cm) above the floor where the dishwasher will be Option C, Waste disposer — with air gap
installed.
Helpful Tip: To reduce vibration of the hose, keep the hose away
from the floor.
Option A, Waste disposer — no air gap
Large blue drain
Hf hose clamp
Rubber hose
connector
Waste disposer — no air gap
Large blues
‘\ Disposer inlets ~ .
SPSS
drain
hose
clamp.
. Drain hose
Drain hose
Drain trap
Drain
trap
1. Using a hammer and screwdriver,
1. Using a hammer and screwdriver, knock plug into disposer.
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
2. Use needle-nose pliers to remove
plug. 3. Connect rubber end of drain hose to
air gap and cut if needed.
NOTE: Do not cut ribbed section.
3. Attach drain hose to disposer inlet yh 4. Attach drain hose to air gap with
with large blue drain hose clamp _ large blue drain hose clamp
(provided). Use pliers to squeeze Ea (provided). Use pliers to squeeze
clamp open and move into position. clamp open and move into position.
If the drain hose was cut, use a 1%”
to 2” (8.8 to 5 cm) screw-type clamp
(not provided).
5. Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from air gap to
disposer inlet.
No waste disposer — no air gap
Large
blue
~~
drain
hose
clamp
~~.
10