Installation guide

Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors.
Wiring configuration
Power supply wire: Terminal box wire:
white <<—>> white
black ~<«—_——»- black
ground wire «<———» ground connector
If needed, see website for animated representation of this step.
Visit www.maytag.com/electrical under FAQ tab.
Power Cord—Secure cord
on strain relief
Tighten strain relief screws to secure cord.
Power Cord—Reinstall
terminal box cover
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use 4" nut driver or Torx® T20® screwdriver
and previously removed screw to secure cover.
NOTE: Do not plug into outlet until instructed to do so.
14
Determine Cabinet Opening
1 | Measure cabinet opening
= i ~~
|
SS
SS
Z|
Measure height of cabinet opening from underside of countertop
to floor where dishwasher will be installed (you will need to
measure the lowest point on the underside of the countertop and
the highest point on the floor). Refer to “Dishwasher Height
Adjustment Chart” for wheel position and the number of turns
needed.
Dishwasher Height Adjustment Chart
Minimum Wheel. |Number of turns) Perforation
cutout height.) position] on frontleg on-blanket
3334" (85.7.cm).| remove. | all the way up remove
33%" (86cm) remove | all the way up keep
34": (86.4:cm) 1 10 keep
3444".(87 em) 2 5 keep
3414" (87.6:cm) 3 0 keep)
NOTE: If the minimum cabinet opening height is less than
34" (86.4 cm), the rear wheels can be removed for additional
clearance. This will allow the dishwasher to fit into a 33%" (86 cm)
high cabinet opening, but the dishwasher will be more difficult to
move. (Measurements are approximate. Wheels and legs are
preset at the factory for 341%" [87.6 cm].) If the minimum cabinet
opening height is 33%" (85.7 cm), a section in the insulation
blanket can be removed by cutting along the perforation.
Cut insulation blanket along perforation