Installation guide

Put dishwasher on its back
Using two or more people, grasp sides of dishwasher door frame
and place dishwasher on its back.
Remove and discard the plastic rail cover on each side of the
dishwasher frame. To remove the plastic rail cover, push upward
and back to unsnap it from the dishwasher frame.
4 | Remove panel and fasteners
4 Unlocked
turn 7 x
Using a flat-blade screwdriver, turn the plastic fasteners 1% turn
counterclockwise to unlock them. Remove panel. Do not remove
tech sheet from access panel.
12
5 Remove terminal box cover
Using a 4" hex head socket, nut driver or Torx® T20® screwdriver,
remove terminal box cover. Retain for later use.
6 Install strain relief
Install a UL Listed/CSA Approved strain relief. Make sure screw
heads are facing to the left when tightening conduit nut. Strain
relief is provided with the power supply cord kit.
What type of electrical
connection will you use?
~-Power- Supply Cord:
-Follow Option A instructions
Direct Wire:
. Follow Option B instructions
NOTE: If using Option B, proceed to “Determine Cabinet
Opening,” to continue with the installation of your dishwasher.