Installation guide

3 | Tighten 90° elbow fitting to valve Connect to Drain
1 Connect drain hose
Small clamp
Black drain hose
connector
Be sure rubber washer is properly seated in fitting. Slide the
¥4" fitting up to the valve and hand tighten to avoid cross-
threading. Hand tighten until the coupling is tight. Place towel under drain hose to catch any water in drain hose.
Using pliers, check the tightness of the coupling. An additional Place the small drain hose clamp onto the small end of the drain
V4 to ¥% turn may be required to seal the rubber gasket. hose. Push the new drain hose into the black drain hose
NOTE: Do not overtighten. Damage to the coupling can result. connector up to the drain hose stop.
4 | Check for leaks
Small clamp
Black drain hose
connector .
Drain hose
Drain hose stop
Stop
Place paper towel under 90° elbow fitting. Turn on water supply Using pliers, squeeze open the small drain hose clamp and slide
and check for leaks. If leak occurs, repeat previous step. onto connector between stops.
If needed, see website for animated representation of this step.
Visit www.maytag.com/watersupply under FAQ tab. " wae
Hose clamp final position
Black drain hose
connector
After hose is connected, remove towel.
If needed, see website for animated representation of this step.
Visit www.maytag.com/drain under FAQ tab.
19