Installation guide

INSTALLATION REQUIREMENTS
All Installations
Tools needed:
Tools and Parts
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with any
tools listed here.
Parts needed:
For-part or kit, see local
Number W10273460
y
Flat-blade
screwdriver
Phillips. a Utility knife Lo
screwdriver LG KS
Ye" and V4" UL-Listed/CSA
nut drivers or
hex sockets
Approved twist-on
wire connectors*
Measuring:tape
or-ruler
Q
Small level
10° adjustable wrench
that opens to
1%" (2.9 cm)
54" open-end
wrench
Torx ®' T20° screwdriver
*Must be the proper size to connect your household wiring
to 16-gauge wiring in dishwasher.
Other useful items you may need:
36" Compr-x 34" hose fitting
retailer or call Whirlpool
Parts: 1-800-442-9991. Part
Other parts you may also need:
15-2"
(3.81-5 cm)
Screw-type
clamps (3 maximum)
Moisture
barrier-tape
(Part Number,
4396277)
Masking:or
NOTE: Parts available for purchase in plumbing supply stores.
Check local codes. Check existing electrical supply. See
“Electrical Requirements’ * section. It is recommended that
electrical connections be made by a licensed electrical installer.
In addition, for first-time installations
Tools needed:
Cordless drill
with 4", %"
QR
Flashlight > Shallow
and 1%" hole
saw bits
Small
tubing cutter
Wire stripper
Parts needed:
Parts supplied:
1 small
Phillips-head| mounting
Drain hose -| Drain #10x %"
clamps (2): hose
(1 large and » screws (2)
Undercounter
brackets (2)
(|
o iz
oO
6
oO 0
9
fe
Make sure all these parts are included in the literature package.
T®TORX and T20 are registered trademarks of Saturn Fasteners, Inc.
Copper. tubing (%" See “Electrical Requirements” section.
OD. suggested)-or
flexible. braided
water supply line
For Direct Wire: | For Power Supply
use UL Listed/-| Cord: use UL
CSA Approved :| Listed/CSA
strain relief Approved power
to fit" (2.2 cm)
supply cord kit
marked for use with
dishwasher