Installation guide

Checkthatlevelinglegsarefirmlyagainstthefloor.

Closeandlatchthedoor,andplacelevelagainstthe

frontpanel.Checkthatdishwasheriscenteredfromfront

tobackintheopening.Ifneeded,adjustlevelingleguntil

dishwasherisplumb.Repeatforothersideofdishwasher.

Helpful"13p:Pushuponfrontofdishwasherto raise

dishwasheroffthegroundtoadjustfrontlegs.With

someinstallations,it maybeeasierto adjustthefrontleg

usingthe3/16"hexheadsocketoradjustablewrench.

Placelevelagainsttopfrontopeningoftub.Checkthat

dishwasherislevelfromsidetoside.If dishwasheris not

level,adjustfrontlegsupordownuntildishwasheris

level.

Connect to Water Supply

Copper tubing only: Slide nut then ferrule

onto copper tubing about 1" (2.5 cm).

NOTE: To avoid vibration during operation, route the

water supply line so that it does not touch the

dishwasher base, frame or motor.

Copper tubing only: Put the tubing into the 90 ° elbow

fitting as far as it will go (the copper tubing bends and

kinks easily). Slide the nut and ferrule forward and start

the nut onto the elbow threads.

Flexible braided connection: Secure nut to elbow using

5/8" open ended wrench or adjustable wrench.

NOTE: Do not use Teflon ®tape with compression fittings.

Hold the 90° elbow fitting still with one adjustable wrench

and tighten the nut with second adjustable wrench.

Helpful "l]p: Use a 5/8" open ended wrench for easier

access to tighten connection.