Owner's Manual

PREPARE DISHWASHER

Helpful Tip: Place cardboard under dishwasher until installed

in cabinet opening to avoid damaging oor covering.

Using two or more people, grasp sides of dishwasher door frame,

and place the dishwasher on its back.

Do not use the door panel as a worktable without rst covering

it with a towel to avoid scratching the door panel.

REMOVE ACCESS PANEL

Using a 5/16" (7.9 mm) nut driver or Phillips screwdriver, remove

the two screws attaching access panel to dishwasher. Once the

screws are removed push the access panel toward the top of the

project to unhook it and then remove it.

DISCONNECT AND REMOVE DRIP PAN

ASSEMBLY

10a. Remove drip pan assembly

To remove the drip pan assembly, press the snap at each side

of the plastic tray in toward the center of the product and pull

toward yourself. Take caution not to pull too far or too hard as the

oat switch wire is still connected at this time.

10b. Remove oat switch wire

To remove the oat switch wire, gently depress the connector

latch tab (1) and then pull the connector (2) out of the housing.

The oat itself should not be removed from the tray.

WARNING

Excessive Weight Hazard

Use two or more people to move and install

dishwasher.

Failure to do so can result in back or other injury.

WARNING

Tip Over Hazard

Do not use dishwasher until completely installed.

Do not push down on open door.

Doing so can result in serious injury or cuts.

8. Put the dishwasher on its back

9. Remove access panel

10. Remove

access

panel

Drip pan assembly