Owner's Manual
17
14. Flexible line
Flexible braided line: Conrm the exible braided line is long
enough.
Get 3/8" compression x 3/4" hose tting with 90° elbow.
Connect the 3/8" compression tting of the 90° elbow tting to
the water supply line. Attach such that the 3/4" connection is
facing upward as shown above.
CONNECT FILL HOSE TO FILL VALVE
16. Tighten 90° elbow tting to valve
Elbow tting
Be sure rubber washer is properly seated in tting. Slide the
3/4" (19 mm) tting of the 90° elbow up to the valve and hand
tighten it to avoid cross-threading. Hand tighten until the coupling
is tight.
Using pliers, check the tightness of the coupling. An additional
1/4 to 1/2 turn may be required to seal the rubber gasket. Route
ll hose out the rear left side of unit.
NOTES:
■ Do not use tape with compression ttings.
■ Do not over-tighten. Damage to the coupling can result.
15. Add 90° elbow tting to the water
supply line