Installation guide

Woodcabinet:Sandholeuntilsmooth.
Metalcabinet:Coverholewithgrommet(PartNumber302797)
includedwithpowersupplycordkit.
l Direct Wire - Drill
Drill a 3/4"(1.9 cm) hole in right-hand cabinet side or rear.
See product and cabinet opening dimensions.
Wood cabinet: Sand hole until smooth.
Metal cabinet: Cover hole with grommet (Part Number 302797 -
not provided).
Route cable from power supply through cabinet hole (cable must
extend to the right front side of cabinet opening).
Tape cable to the floor in area shown. This will prohibit cable from
moving when dishwasher is moved into cabinet opening.
Helpful Tip: Routing the water line through the left side of
cabinet opening will make water connection easier.
Drill a V2"(1.3 cm) hole in the cabinet side or rear.
Measure overall length of copper tubing or flexible braided
water supply line. Attach to the hot water line using a
connection configuration that is in compliance with local codes
and ordinances. The water line to the dishwasher should have a
manual shutoff valve.