Installation guide

1.Connectblackendofofdrainhosetowaste
teeandcutifneeded.
(Donotcutribbedsection.)
2.Attachblackendofdrainhosetowastetee
withalargesilverdrainhoseclamp(provided).
Useplierstosqueezeclampopenandmove
intoposition.Ifthedrainhosewascutusea
1W'to2"(3.8to5cm)screw-typeclamp(not
provided).
Option C, Waste disposer = with air gap
Drain trap
1. Using a hammer and screwdriver, knock
plug into disposer.
2. Use needle-nose pliers to remove plug.
3. Connect black end of drain hose to air gap
and cut if needed. (Do not cut ribbed
section.)
4.
5,
Attach drain hose to air gap with large
silver drain hose clamp (provided). Use
pliers to squeeze clamp open and move
into position. If the drain hose was cut, use
a 11/2"to 2" (3.8 to 5 cm) screw-type clamp
(not provided).
Use a rubber hose (not provided)with
screw-type clamps (not provided) to
connect from air gap to disposer inlet.
1. Connect black end of drain hose to air gap
and cut if needed. (Do not cut ribbed
section.)
2. Attach drain hose to air gap with large silver
drain hose clamp (provided).
Use pliers to squeeze clamp open and move
into position. If the drain hose was cut, use a
11A"to 2" (3.8 to 5 cm) screw-type clamp
(not provided).
3. Use a rubber hose (not provided) with
screw-type clamps (not provided) to
connect from waste tee to air gap.