Installation guide

337/8"(8&0cm) Removed AI!thewayup

J J

341/4" (87 cm). 2 5

341/2'' (87:6 cm)

NOTE: If the minimum cabinet opening height is less than 34"

(86.4 cm), the rear wheels can be removed for additional

clearance. This will allow the dishwasher to fit into a 337/8"

(86 cm) high cabinet opening, but the dishwasher will be more

difficult to move. (Measurements are approximate. Wheels and

legs are preset at the factory for 341/2" (87.6" cm).)

Turn both leveler legs to the same height. Put wheels in the

required position determined from "Dishwasher Height

Adjustment Chart". (To change wheel position, use a fiat-blade

screwdriver to pop out the wheel, then snap into the new

position.)

Built-up floors (Kitchen floor height is higher than cabinet

opening.) Example: Kitchen floor tile does not extend into

cabinet opening. Add shims as needed in the area shown to

bring the dishwasher up to 34" (86.4 cm) below the countertop.

NOTE: Shims must be securely attached to floor to prohibit

movement when the dishwasher is in use.

stud ..................

Mounting

Handle

Setscrew (i nside tt

door handle standoff) I_ Allen wrench ....

IMPORTANT: Do not scratch the front panel during this

procedure.

Remove the door handle and hardware bag containing

the setscrews and Allen wrench from the cardboard box.

Start setscrews in handle. Place handle on mounting

studs with the setscrews facing down. Push the door

handle tightly against the door. Insert the short end of the

Allen wrench into the setscrews. Tighten the setscrews

1/4turn past snug.

1 JStand dishwasher upright

Using two or more people, stand dishwasher upright.

NOTE: Do not install kickplate until instructed.