Installation guide

Cable

IMPORTANT: Double check correct placement of utilities. Grasp

the sides of the dishwasher at the edges of the door panel. Tilt

dishwasher backwards on wheels and move dishwasher close to

cabinet opening.

NOTE: Do not push on the front of the panel or on the

console-they may dent.

Helpful Tip: Temporarily tape utilities to the floor in the

locations shown to prohibit them from moving when

dishwasher is moved into the cabinet opening.

Check that water line is on the left side of opening and drain

hose is near the center of the cabinet o _ening.

With another person holding the dishwasher to avoid it from

tipping, open and close the door a few times. If the door closes

or falls open under its own weight, the door tension will need to

be adjusted.

If the door closes too quickly, decrease the spring tension by

moving the spring end toward the front of

the dishwasher.

NOTE: Springs should be in the same notches on left and right

sides.

If the door falls open, increase the spring tension by moving the

spring end toward the back of the dishwasher.

NOTE: Springs should be in the same notches on left and right

sides.

IMPORTANT: If wheels were removed, avoid damage to the floor

when moving the dishwasher. Slowly move dishwasher

completely into cabinet opening. Do not kink or pinch water line,

drain hose, power supply cord or direct wire between dishwasher

and cabinet. Remove cardboard from under dishwasher.

NOTE: It is all right if dishwasher fits tightly into cabinet opening.

Do not remove insulation blanket- the blanket reduces the

sound level.

NOTE: If using power cord, make sure to route end through hole

in cutout before sliding into cabinet opening.