Installation guide

Holdthe90°elbowfittingstillwithoneadjustablewrenchand
tightenthenutwithsecondadjustablewrench.
Helpful Tip: Use a 5/8open ended wrench for easier access to
tighten connection.
Place paper towel under 90 ° elbow fitting. Turn on water
supply and check for leaks. If leak occurs, repeat previous step.
If needed, see website for animated representation
of this step. Visit ww_v.whirlpool.com/watersupply under FAQ
tab.
Place towel under drain hose to catch any water in drain hose.
Place the small green drain hose clamp onto the small end of
the drain hose. Push the new drain hose into the black drain
hose connector up to the drain hose stop.
16
Using pliers, squeeze open the small green drain hose clamp
and slide onto connector between stops.
Once connected, remove towel.
If needed, see website for animated representation of this step.
Visit www.whirlpool.com/drain under FAO tab.
NOTE: If the power supply cord was connected earlier
proceed to Secure Dishwasher in Cabinet Opening section.
Option B, Direct Wire:
#
Route cable so that it does not touch dishwasher motor or
lower part of dishwasher tub. Pull cable through cable clamp in
terminal box.
Select UL Listed/CSA Approved twist-on wire connectors
(not included) rated to connect your household wiring to 16-gauge
dishwasher wiring.