Installation guide

Placepapertowelunder90° elbowfitting.Turnonwater

supplyandcheckfor leaks.If leakoccurs,repeat

previousstep.

If needed,seewebsiteforanimatedrepresentation

ofthisstep.Visitwww.maytag.com/drainunder

FAQtab.

Connect to Drain

j Connect drain hose

Green clamp

Black drain hose Drain hose

connector --

Drain hose stop

Sto p

Place towel under drain hose to catch any water in drain

hose. Place the small green drain hose clamp onto the

small end of the drain hose. Push the new drain hose

into the black drain hose connector up to the drain hose

stop.

Using pliers, squeeze open the small green drain hose

clamp and slide onto connector between stops.

Hose clamp final position

Drain hose

Black drain hose

connector --

Green clamp

Drain hose stop

Stop

After hose is connected, remove towel.

If needed, see website for animated representation of

this step. Visit www.maytag.com/drain under FAQ tab.

Make Direct Wire Electrical

Connection

NOTE: If the power supply cord was connected earlier

proceed to "Secure Dishwasher in Cabinet Opening"

section.

Option B, Direct Wire:

Route cable so that it does not touch dishwasher motor

or lower part of dishwasher tub. Pull cable through cable

clamp in terminal box.

Select UL listed or CSA approved twist-on wire connectors

(not included) rated to connect your household wiring to

16-gauge dishwasher wiring.