Installation guide

7
Tools Needed:
203 mm (8") 203 mm (8") or 254 mm (10") Flat-Blade Screwdriver Phillips Screwdriver
or 254 mm (10") Adjustable Wrench
Pipe Wrench that opens to 25 mm ( 1")
Torx
†
T-20
†
Security 25 mm (1") Hex-Head 8 mm ( 5⁄16") Socket Wrench Pliers (that open to
Screwdriver or Bit Socket Wrench 39 mm [1
9
/
16
"])
Level Utility Knife 6 mm (1/4") Nut Driver 686 mm (27")
Wood Block
Caulk Gun and Caulk Vent Clamps Pipe-Joint Compound Putty Knife
(for installing new exhaust vent) Suitable for Gas Type
Flashlight (optional) 25 mm (1") Ruler or Measuring Tape
Open-End Wrenches
TOOLS & PARTS
Parts Supplied:
Foot Boots (4) Leveling Legs (4) Security Cone 5/16" Hex Head – 18 x 2
1
⁄2"
Security Bolt
NOTE: The circuit diagram for this dryer is located inside the
lower front panel, within the Tech Sheets.
Technical Specifications:
220 – 240 V, 50 Hz. AC
4575W
Total mass: 68 kg max.
Clothes Capacity:
IEC Capacity
9 kg
NOTE: Sound Pressure Level, LpA: 58 dB(A)
[uncertainty, KpA: +/–10 dB(A)].
†TORX and T20 are trademarks of Acument Intellectual Properties, LLC.