Installation Guide

Reverse door swing square-shaped door

1. Remove door from dryer

Using a TORX T25

screwdriver, remove the 4 screws

securing the door hinge to the dryer and lift up and out to

remove the door. Place the door on a soft towel or other

non-scratch surface. Retain or set aside the 4 screws.

2. Move the door strike

Using a TORX T25

screwdriver, remove the 2 screws

securing the door strike to the door frame of the dryer.

Remove the 4 screws above and below the door strike and

set aside for later use. Rotate the strike 180° and attach to

the opposite side of dryer door frame, as shown.

3. Remove inner door from

outer door

Position the door with the inside of the door facing up. Using

a Phillips screwdriver, remove the 13 screws securing the

inner door to the outer door. Lift off the inner door and set

aside.

NOTE: There is a small release tab on each side of the door.

If the inner and outer door do not separate easily, slide a

credit card, putty knife, or similar at object between the inner

and outer doors at the locations shown to release the tab.

Release tab

7. Reinstall door on dryer

Using a TORX T25

screwdriver, remove the 4 screws on the

dryer. Insert the tabs on the hinge into the mounting slot and

slide down to engage the top tab. Secure in place with

the 4 TORX T25

screws removed earlier.