Installation guide

TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed:
INSTALLATION REQUIREMENTS
=p
C=
Flat-blade screwdriver #2 Phillips screwdriver
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Level
CJ ST
HS
m1
Wire stripper (direct wire Vent clamps
installations)
Ce
he SS
Caulking gun and
compound (for installing
new exhaust vent)
Tin snips (new vent
installations)
1/4" nut driver
(recommended)
—_ ==
Pliers
Tape measure
Parts supplied (ail models):
Leveling legs (4)
Parts supplied (steam models):
“Y¥” connector
e—
5' inlet hose
Short inlet hose
Rubber washer
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See “Electrical Requirements” and “Venting Requirements”
before purchasing parts.
Mobile home installations require metal exhuast system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the “Assistance
or Service” section in your “Use and Care Guide”.
Optional Equipment: (Not supplied with dryer)
Refer to your “Use and Care Guide” for information about
accessories available for your dryer.