Installation Instructions

7
INSTALL LEVELING LEGS
1. Prepare dryer for leveling legs
To avoid damaging  oor, use a large  at piece of cardboard
from dryer carton; place under entire back edge of dryer.
Firmly grasp dryer body (not console panel) and gently lay
dryer down on cardboard.
2. Screw in leveling legs
Using a wrench and tape measure, screw legs into leg holes
until bottom of foot is approximately 1½" (38 mm) from
bottom of dryer.
Now stand the dryer on its legs. Slide the dryer until it is
close to its  nal location. Leave enough room for electrical
connection and to connect the exhaust vent.
NOTE: Refer to “Dryer Dimensions” in “Location
Requirements.”
ELECTRICAL CONNECTION
Power Supply Cord
Electrical Connection Options
1. Choose electrical connection type
Power supply cord 4-wire receptacle
(NEMA Type 14-30R): Go to “4-Wire
Power Supply Cord Connection” section.
Then, go to “Venting Requirements.”
3-wire direct connection: Go to “3-Wire
Direct Wire Connection” section. Then go
to “Venting Requirements.”
4-wire direct connection: Go to “4-Wire
Direct Wire Connection” section. Then go
to “Venting Requirements.”
Power supply cord 3-wire receptacle
(NEMA Type 10-30R): Go to “3-Wire
Power Supply Cord Connection” section.
Then go to “Venting Requirements.”
NOTE: If local codes do not permit connection of a
cabinet-ground conductor to neutral wire, go to “Optional
3-Wire Connection” section. This connection may be
used with either a power supply cord or a direct wire
connection.