Installation guide

3. Feed the CSA approved flexible conduit (A) through the
opening in the bottom of the oven.
IMPORTANT: Connect the CSA approved flexible conduit so
that the warning label lies outside the oven.
A. CSA approved flexible conduit
B. Warning label
Connect red wire (D) to the middle terminal block post,
connect the yellow/green wire (C) to the right terminal block
post, and connect the black wire (B) to the left terminal block
post. See the following illustration.
D. Red wire (L2)
E. Screws
F. Opening in oven bottom
A. CSA approved flexible conduit
B. Black wire (L1)
C. Yellow/green wire (GND)
9
91
10.
11.
Tighten screws (E) on CSA approved flexible conduit (A).
Reinstall terminal box cover.
Feed the CSA approved flexible conduit from the oven
through the opening in the cabinet.
Remove junction box cover, if it is present.
Install a CSA approved conduit connector to the junction box.
A. CSA approved conduit connector
Route the CSA approved flexible conduit from the oven to the
junction box through the CSA approved conduit connector.
Tighten screws on conduit connector.
4-Wire Cable from Home Power Supply
A.
B.
C.
D.
E. Junction box 4-wire cable from home power supply
Red wires F. White wire (from home
Green (bare) wire (GND) from home power supply)
power supply G. Wire connector
Yellow/green wire (GND) from oven
3-wire CSA approved flexible conduit
from oven
H. Black wires
|, CSA approved conduit
connector
Connect the 2 black wires (H) together using a CSA approved
wire connector.
Connect the 2 red wires (B) together using a CSA approved
wire connector.
Connect the yellow/green wire (C) from the oven to the green
(bare) wire from the home power supply using a CSA
approved wire connector.
Put a wire connector on the end of the white wire (F).
NOTE: Do not connect the yellow/green wire to the white wire
in the junction box.
Install junction box cover.
Reconnect power.