User`s guide

Oven Bottom s. Reverse procedure to reinstall. If gas line has been

disconnected, check for gas leaks after reconnection

Protect oven bottom against spillovers, especially acid or NOTE: A qualified servicer should disconnect and re-

sugary spills, as they may discolor the porcelain enamel. Use connect the gas supply.

the correct pan size to avoid spillovers and boilovers. Do not

6. To prevent range from accidentally tipping, range must

place aluminum foil directly on the oven bottom.

be secured to the floor by sliding rear leveling leg into the

The oven bottom may be t_ _ anti-tip bracket.

removed for easier clean-

ing.

To remove: When cool, (( Proportional Valve Adjustment

remove the oven racks. _ 2 for Surface Burners

Slide the two catches, lo-

cated at each rear corner The LOW setting should pro-

oftheovenbottom, to- _ _ duceastableflamewhentum-

wardthefrontoftheoven, t3 ing the knob from HIGH to

LOW. The flame should be 1/8

Lift the rear edge of the inch or lower and must be stable

oven bottom slightly, then on all ports on LOW setting.

slide it back until the front edge of the oven bottom clears the

oven front frame. Remove oven bottom from oven. To adjust: Operate burner on

HIGH for about five minutes to

To replace: Fit the front edge of the oven bottom into the preheat burner cap. Turn knob back to LOW; remove knob,

oven front frame. Lower the rear of the oven bottom and slide and insert a small screwdriver into the center of the valve

the two catches back to lock the oven bottom in place, stem. Adjust the flame size by turning adjustment screw in

eithcr dircction, while holding the stem.

How to Remove Range Flame must be of sufficient size to be stable on all burner

for Cleaning and Servicing ports. If flame adjustment is needed, adjust ONLY on the

LOW setting. Never adjust flame size on a higher setting.

Follow these procedures to remove appliance for cleaning or NOTE: All gas adjustments should be done by a quali-

servicing: fled servicer only.

1. Shut off gas supply to appliance.

2. Disconnect electrical supply to appliance, if equipped.

3. Disconnect gas supply tubing to appliance.

4. Slide range forward to disengage range from the anti-tip

bracket. (See Installation Instructions for location of

bracket.)