Installation Instruction

15
3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with a 5/8"
(1.6 cm) combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
“

LP” is facing the direction shown in the above drawing
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Natural Gas to Propane
Gas)
1. Remove burner cap.
2. Using a Phillips or Quadrex
®
screwdriver, remove the burner
base.
NOTE: Reinstall one of the screws through the range
cooktop to hold the orice spud holder in place while
removing and replacing the orice spuds.
3. Apply masking tape to the end of a 9/32" (7 mm) nut driver
to help hold the gas orice spud in the nut driver while
changing it. Press nut driver down onto the gas orice spud
and remove by turning it counterclockwise and lifting out.
Set gas orice spud aside.
4. Remove the cardboard orice spud holder shipped in the
literature package in the oven. Gas orice spuds are
stamped with a number, marked with 1 color dot, and have a
groove in the hex area. Replace the Natural gas orice spud
with the correct Propane gas orice spud.
Refer to the following chart for correct Propane gas orice
spud placement.
Propane Gas Orice Spud Chart for Surface Burner
Placement Burner
Rating/Type
Size (mm) ID Number
LF 14,200 BTU 1.08 108AM
LR 8,000 BTU 0.84 084AM
RF 14,200 BTU 1.08 108AM
RR 5,000 BTU 0.64 064AM
CTR 8,000 BTU 0.84 084AM
NOTE: Refer to the Model/Serial/rating Plate located on the oven
frame behind the top left side of the oven door for proper sizing
of spuds for each burner location.
5. Place Natural gas orice spuds in the cardboard orice spud
holder.
6. Replace the burner base using both screw.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
A
B
C
D
Side view before
Side view after
E
NG
LP
NG
LP
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
A
B
C
D
A. Igniter electrode
B. Gas tube opening
C. Burner cap
D. Burner base
B
A
C
D
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
A
A. Propane groove