Manual

Cooktn
LO: Use to simmer foods, keep foods
warm and melt chocolate or butter. Some
cooking may take place on the LO setting
if the pan is covered.
HI: Use to bring liquid to a boil, or reach
pressure in a pressure cooker. Always
reduce setting to a lower heat when liquids
begin to boil or foods begin to cook.
An intermediate flame size is used to
continue cooking. Food will not cook any
faster when a higher flame setting is used
than needed to maintain a gentle boil.
Water boils at the same temperature
whether boiling gently or vigorously.
Surface Controls
O O Graphics next to the knob identifywhich burner the
knob controls. For example, the graphic at left shows
O O the left front burner location.
Pilotless ignition
Pilotless ignitioneliminates the need for a constant standing
pilot light. There are two ignitors for conventional surface
burners. Each sealed burner has a spark ignitor. When
cleaning around the surface burner use care. If cleaning cloth
should catch the ignitor, it could
damage it preventing ignitior_ _HEAD
If the surface burner AK
does not light, check / _,, " J X
if ignitor isbroker,, (_ _ _/L -1
soiled or wet. If PORTS_/_--___.____ J
clogged, clean _.
the small port beneath tl!e __IGNITOR
ignitor using a straight pin.
PORT BELOW IGNITOR
Surface Control Knobs
Use to turn on the surface burners. An infinitechoice of heat
settings is available from LO to HI. At tire HI setting a detent
or notch may be felt, The knobs can be set on or between any
of the settings,
Setting the controls:
Tire size and type of cookware will affect the heat setting.
1. Place a pan on the burner grate.
• The burner flame may lift off or appear separated from
the port if a parr is not placed on the grate.
2. Push in and turn the knob counterclockwise to the LITE
setting.
• A clicking (spark:) sound will be heard and the burner
will light. (All four ignitors will spark when any surface
burner knob is turned to the LITE position.:)
3. After the burner lights, turn knob to desired flame size.
• The ignitor will corrtinue to spark until the knob is
turned past the LITE position.
Operating During a
Power Failure
1. Hold a lighted match to the desired surface burner head.
2. Push in and turn the corrtrol knob slowly to LITE.
3. Once lit, adjust the flame to the desired level.
5