Technical Manual

FOR SERVICE TECHNICIAN’S USE ONLY

DO NOT REMOVE OR DESTROY32

Removing the Water Inlet Valve

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

NOTE: The water inlet valve is replaced as an assembly, which includes all

four valves, bracket, and valve assembly harness.

1. Unplug washer or disconnect power.

2. Turn off the water supply to the washer.

3. Disconnect hot and cold inlet water hoses.

4. Complete the steps 1-8 from section Removing the Console.

5. Disconnect the Water Inlet Valve connector from the ACU (connector

varies depending on model, features, and control board).

6. Using a 1/4" nut driver, remove the two (2) hex-head screws (one on

each side) securing the water inlet valve to the Top Panel of the washer.

Removing the Main Control

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

NOTE: ACU may vary depending on model number and features.

1. Unplug washer or disconnect power.

2. Turn off the water supply to the washer.

3. Complete the steps 1-8 from section Removing the Console.

4. Remove pressure hose from ACU.

5. Disconnect all connectors from the ACU.

6. Using a 1/4" nut driver, remove the hex-head screw securing the ACU to

the Top Panel of the washer as shown in above figure. Slide ACU to the

left and lift to remove.

A. ACU Screw B. ACU Connectors