Technical Manual

DO NOT REMOVE OR DESTROY

FOR SERVICE TECHNICIAN’S USE ONLY

As an alternative to the previous steps, the belt, motor, splutch, shifter, and

capacitor may also be removed along with the gearcase as outlined below:

1. Unplug washer or disconnect power.

2. Turn off the water supply to the washer.

3. Remove the basket. See the section Removing the Basket.

4. Use cardboard or padding to lay washer on the front cabinet.

5. Unplug the harness from the motor.

6. Unplug the harness from Shifter.

7. Unplug the harness from the capacitor.

8. Remove the four (4) mounting bolts and pull the gearcase out of the tub

NOTE: The tub and gearcase has eight (8) mounting holes. Only four (4)

are used. If they strip out during reassembly, the other holes can be used to

re-mount the gearcase.