Installation Instructions

7
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie.
It is the responsibility of the installer to install and secure the
drain hose into the provided plumbing/drain in a manner that
will avoid the drain hose coming out of or leaking from the
plumbing/drain.
Level Washer
IMPORTANT: Level washer properly to reduce excess noise
and vibration.
Move the washer to its final location. Place a level on top
edges of washer. Use side seam as a guide to check levelness
of sides. Check levelness of front using lid as shown. Rock
washer back and forth to make sure all four feet make solid
contact with floor. If washer is level, skip to Step 15.
13. Check levelness of washer
Place level herePlace level here
Not Level
LEVEL
Not Level
12. Secure drain hose
4.5"
(114 mm)
4.5"
(114 mm)
4.5"
(114 mm)
4.5"
(113 mm)
4.5"
(114 mm)
Laundry Tub Standpipe Wall
If washer is not level:
Use adjustable pliers to turn the plastic leveling foot
counterclockwise to lower the washer or clockwise to raise
the washer. On all models, recheck levelness of washer and
repeat as needed.
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
14. Adjust leveling feet
15. Plug into a grounded 3 prong outlet