Use & Care Manual

Replacing the Incandescent Light Bulb

Turn off the range hood and allow the light bulb to cool.

1. Disconnect power.

2. Squeeze the plastic lens cover and remove it from the hood.

3. Screw a 120V, 75W maximum, incandescent light bulb with

E26 base into the socket.

4. Replace the lens cover by squeezing the cover and inserting

the tabs into the slots.

5. Reconnect power.

If the new light does not operate, make sure the light bulb is

inserted correctly before calling service.

WIRING DIAGRAM

0.9 ±10% A

50 ±10% Watts

22.3 ±10% Ohms

13.4 ±10% Ohms

Motor Characteristics

Power Supply

120 VAC

Frequency

60 Hz

Amperage

Wattage Rating

Motor Resistance

White - Red

White - Black

Light Switch

On - Off

Motor Switch

Low - Off - High

Speed 2

Common

Speed 1

GND

Ground

Screw