Installation guide

6, Remove screws from door

Remove screws at top, bottom, and side of door (4 screws).

Keep door screws separate from hinge screws as they are

different sizes.

7, Separate inner from outer door

9, Attach door hinges

Holding door over towel on dryer, pry inner door and lift to

separate it from outer door.

NOTE: Do not pull on door seal or plastic door catches.

8, Rotate outer door

Rotate outer door 180 ° and set it back down on inner door.

Be certain to keep cardboard spacer centered between

doors. Reattach outer door panel to inner door panel so

handle is on the side where hinges were just removed. Insert

4 door screws.

Reattach door hinges to dryer door so that the larger hole is

at the bottom of the hinge.

strike label

Remove door strike and door strike label from dryer cabinet.

Insert the door strike into hole where door strike label was

removed and secure with screw. Cover original door strike

hole with door strike label and press firmly into place.